Description
LINNEY ENGINER GT-R FRONT BILLET CROWN WHEEL & PINION SET
Linney Engineering Billet Front Crown Wheel & Pinion set is up to 50% stronger by design and material specifications. These gears are designed to give maximum performance while retaining OE Nissan GT-R front stock casings with no other modifications. Material specification EN36C & compatible with stock bearings.
- Face milled ground bevel gears for strength and control compared to face hobbed tooth forms
- EN36C Steel
- DIN 5 Quality
- Gear Cut – Gleason
- Gear Grind – Gleason Phoenix CNC grinder
- Gear Measurement – Gleason 475GMS CNC
- Design – Gleason software
- Shot peened
- Case harden
- Heat Treated
- Extremely smooth and quiet running
- Fits OEM and aftermarket LSD
- Fits OEM or billet casing
- Fits OEM Bearings compatible
Stock OEM Nissan GTR Ring & Pinion failure can be quite common on higher-powered vehicles, especially for Drag, Circuit, Roll racing, and other high-speed use. When this failure occurs as shown in the image below this causes catastrophic damage usually destroying the front differential & housing and also commonly damaging the engine block!
For peace of mind when building your GTR its worth the consideration to install a set of Linney Engineering Billet Front diff gears!
Sample Image Damaged Stock R35 GT-R Front Diff Gears
GT-R Front CWP Backlash 0.10-0.15
Note: Professional installation is essential clearance/lash/shimming is required. Incorrect setup, running low on oil, locked and or a damaged ETS unit will cause terminal damage to your FWD.. Must be used with billet side bearing to prevent bolts backing out (OEM side bearing can crack).
There is no warranty stated or implied due to the stresses placed on your vehicle by performance parts and our inability to monitor their use, tuning, or modification.
You may also like...
Trusted by over 100,000 customers
Your Cart
Your cart is currently empty.